Product Description
 |
 |
 |
 |
Key Features
• 45 degree metal housing
• Good visual alignment with the angled display
• Ideal for wall or desk mount
• Mounting base available in Black or White finish
• Bracket available in White, Black or Metallic finish
* T430, T440 and T460 controllers not included
JED controllers are physically based on the Australian/NZ power point standards, particularly the Clipsal 2000 series. The 449A is a moulded mounting block 122mm long, 78mm wide and 32mm deep. The T430/T440 and T460R controllers all can screw onto this base and mount on a masonry wall with rear or side, top or bottom cable entry.
These bases are available from JED in white, black or "metallic" (to suit the T460R-M or T440 code B-M metallic-finished controllers.)
The 45 degree metal housing manufactured by JED to mount JED controllers. This four-piece assembly can be used in standard (bottom cable entry) mode or inverted (rear cable entry) mode. These modes both hold the controllers at 45 degrees to the operator's desk or wall for good visual alignment with the display. The standard mode is used where the controller is bolted on top or a desk or cabinet with cables through the base. The rear entry mode allows it to be bolted to a wall at a lower level than the operator's eye-line.
These metal units are available in powder-coated white, black or bare (for installers to paint any colour they desire.)
