Product Description
Key Features
• 2 x 120W RMS per channel power amplifier with Dante
• 240W output for 70/100V in Bridge mode (direct drive)
• Stereo into 4-8 ohm loads
• Trigger could be external remote ON/OFF
• Slot card with integrated Dante receiver
• Short circuit & overheating protection
Features
- Stereo into 4-8 ohm loads
- Bridgeable for 70V or 100V (Direct Drive)
- Slot card with integrated Dante receiver
- Power down after -15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby
- Yellow LED (Front Panel) to indicated Standby mode is active
- Terminal Block analogue audio inputs on 2 CH amp
- 2 x amplifier outputs, bridgeable to 1 channel
- Volume, Auto on/off signal sensing
- Natural cooling without Fan
- TRIGGER could be external remoting ON/OFF
- Short circuit protection
- Overheating protection
Specifications
DANTE AUDIO INTERFACE
- 2x2 audio channels
- I2S digital audio format
- 16, 24 or 32-bit audio samples (per device or per channel)
- 44.1 KHz, 48KHz, 88.2KHz and 96KHz sample rate
NETWORK INTERFACE
- Standard 100Mbps Ethernet
- RMII Ethernet interface with MDIO
- Hardware time-stamping, supporting sample-accurate playback
- Transmit flows: 2 (unicast or multicast)
- Receive flows: 2 (unicast or multicast)
- Latency from 2ms
AMPLIFIER/ RATED POWER
- 4 ohm Stereo Mode = 120W (22 V) RMS output (steady state). per channel @ < 1 % THD+N
- B ohm Stereo Mode = 120W (31 V) RMS output (steady state), per channel @ < 1 % THD+N
- 70V Bridge Mode = 240 W output (steady state), per channel@ < 1 % THD+N
- 100V Bridge Mode = 240 W output (steady state), per channel@< 1 % THD+N
- 1/8 Rated Power Run Time: continuous operation
- Frequency Response: 20Hz-20kHz +0/-2dB @ 4ohm load
- Signal to Noise: >90dB A WTD
- Dimension: 214mm(W) x 249.Bmm(D) x 44mm(H)