Product Description
 |
 |
 |
 |
 |
Key Features
• Two high current 16 Amp relay outputs
• Operation indicators on all relay outputs
• RS232/485 input
• Wallplate connection via standard UTP cabling
• Powered by 24V DC input (passes power to wallplate)
• Compatible with Redback Touch wallplates or third party serial control systems
Designed to be used in conjunction with Redback Touch programmable touchscreen wallplates, as a standalone system or as an expansion hub for the A 6505A, this control hub consists of 2 high current (16A) relays with isolated sets of voltage free contacts that close on operation.
When used with a Redback Touch wallplate, the connection to the wallplate is via Cat5/6 cable up to 50m away. All commands from the programmed plate are then transported to this hub and the appropriate RS232/485 command signal is then output to the corresponding pluggable terminals. This could be used for controlling an AV system in a classroom, lecture theatre, board room etc. The serial outputs could be used to control a projector and amplifier. Requires 24V DC power which in turn powers the connected wallplate.
The relay hub can be used in three ways:
- Direct connection via Cat5/6 UTP cable to a Redback Touch wallplate, which is programmed to control relay activation.
- As an expansion to the A 6505A hub, increasing the total number of relay contacts from 3 to 15. In this configuration, one of the serial outputs of the A 6505A would be used to control the A 6510. These hubs should be located as close together as possible.
- As a standalone serial controlled relay hub for use with any third party system utilising RS232/485.
Specifications
Input Connectors
- Power connection (24V DC): 2.1mm DC socket, Euroblock terminal
- Data: RJ45 8P8C
Output Connectors
- Relay (1-2) Switched Out: Screw Terminals
- NOTE: Relays rated for low power, typical 24V DC switching
Mechanical
- Dimensions: 75W x 133D x 47H.
- Current Draw: 30mA (idle) 80mA (Max)
- Weight:0.19kg
*Specifications are subject to change without notice.
Optional Accessory
24V DC 1A Power Supply Adapter
- Input Range: 100V to 240V AC
- Output Voltage: 24V DC
- Output Current: 1A
- Barrel length: 10mm
- Plug tip type: 5.5mm outer diameter and 2.1mm inside diameter
- Polarity: Positive centre
- Cable length: 1.2m
- MEPS efficiency level: V
- Australian standards compliant
- Suitable for a range of electronic devices
- Compatible with Australian mains power point
