Product Description
 |
 |
 |
 |
Key Features
• 250 Watts (8 ohm) / 500 Watts (4 ohm) RMS Power output
• Dual subwoofer outputs in parallel configuration
• Optimised for use with Dual8, BSub12 & HSub10 subwoofers
• Adjustable Crossover (40 to 250 Hz), Phase and Volume
• 3 Custom EQ settings, 12V trigger In/Out and various power mode selection
Episode® Digital Subwoofer Amplifier - 500W with Front Panel Display
This digital subwoofer amplifier with front panel display and dual sub outputs runs steady at 500 Watts at 4 ohm, and is fine-tuned with custom EQ settings to be used with our dual 8" in-wall, 10” hardscape, or 12” burial subs.
|
|
|
|
Front Panel DisplayThis amp’s front panel screen displays the volume level and other control settings. Access the menu function screen using the selection knob to adjust volume, crossover, phase, and EQ settings. It also allows you to select sound mode, night mode, and power mode settings, and can assign an IR device ID for control system integration. Plus, there is a lock control setting that prevents accidental changes in settings. |
Custom EQ SettingsThis Episode® amplifier offers flexibility to enable or disable EQ settings. There are 3 custom EQ settings optimized for our subwoofers. |
|
 |
 |
|
Power Mode SelectionIntelligent power management allows the amp to turn on automatically, either when an audio signal is detected or by using a 12V trigger from your AV receiver or processor. An illuminated front-mounted push button also allows you to turn the amplifier on or off when set to the always-on mode. |
ConnectionsRCA line level inputs and pass-through outputs allow you to connect additional amplifiers, while the 12V trigger input and output allows you to connect another 12V trigger device; the amp also has dual sub outputs in parallel configuration |
|
|
|
|
|
Control System IntegrationFeatures an IR port to connect an IR device. Simply connect an IR repeater or IR controls system to the IR port on the back of the amplifier, and set the device ID in the front panel controls menu. |
Subsonic CircuitsA limiter circuit has been incorporated into the amp to protect the connected subwoofer from harsh or damaging distortion that could not only ruin the listening experience, but the woofer |
|
|
|
|
|
|
|
|
|
Rackmount Installation OptionRack ears with three fastening points help eliminate sag when the amp is installed into a rack, while top cover and side panel ventilation slots allow better airflow. |
|
Specifications
| Impedance Input | 15.000 ohms |
| Power Output @ 4 ohm | 500W RMS |
| Power Output @ 8 ohm | 250W RMS |
| Sensitivity Input | 100 mV for 500W output 4 ohms |
| Total Harmonic Distortion (THD) | < 0.2% |
| Frequency Response | "1.1 db at 300 Hz (Flat EQ, LFE Crossover Setting) 1.5 dB at 20 Hz" |
| 12V Trigger | 2.6V |
| Certifications | TUV listed Tested under UL/EN60065 for US and Canada |
| Dimensions (W x H x D) | 16.9" x 1.75" x 8.1 |
| Weight | 8.5 lb |
| Rack Spacing | 1U |
| Signal to Noise Ratio | 88 dB (5 kHz bandwidth relative to 500W @ 4 ohms) |
| Channels | 1-Channel |
| External Trigger Voltage | 12V +/-1.2V no load 10.5 V with 100 mA load |
